Frigidaire pld4460rec Operating Guide

12

—

Occasionally wipe with a mild, 

nonabrasive detergent and water. Rinse and dry.

—The inside of the dishwasher is self-

cleaning with normal use. If needed, clean around 

the tub gasket area with a damp cloth.

—keeps dishwasher from 

overfilling and is located in the right front corner of 

the tub.

•  Clean occasionally 

with household cleaner 

containing vinegar to 

dissolve any buildup.

•  Overfill protector should 

move up and down freely 

about one inch. If it does 

not move, lift and clean 

underneath.

If a drain air gap was installed for your built-in 

dishwasher, check to make sure it is clean so 

the dishwasher will drain properly. A drain air gap 

is usually mounted on countertop and can be 

inspected by removing the cover. This is not part of 

your dishwasher and is not covered by warranty.

Note: Hard water may cause lime deposit buildup 

on the interior of the dishwasher. For cleaning 

instructions see “Removing Spots and Film” 

section.

A dishwasher left in an unheated place should be 

protected from freezing. Have a qualified person 

do the following:

1.  Turn off electrical power to the dishwasher at 

the supply source by removing fuses or turning 

off the circuit breaker.

2.  Shut off water supply.
3.  Place a pan under the inlet valve. Disconnect 

water line from inlet valve and drain into pan.

4.  Disconnect drain line from pump and drain 

water into pan.

Note: See Installation Instructions for more 

details.

1.  Reconnect the water, drain, and electrical 

power supply.

2.  Turn on water and electrical power supply.
3.  Fill both detergent cups and run dishwasher 

through a Heavy Wash cycle.

4.  Check connections to make sure they do not 

leak.

Note: See Installation Instructions for more 

details.

Freezing temperatures may cause water lines to 

rupture. Be sure all supply lines to and  

circulating lines within dishwasher are protected.
Failure to do so could result in property damage. 

Allow heating element to cool 

before cleaning the interior.
Failure to do so can result in 

burns.