Frigidaire pld4460rec Operating Guide

3

Note: Cycle times are approximate and will vary 

with options selected. Hot water is necessary to 

activate dishwasher detergent and melt fatty food 

soils. An automatic sensor will check the incoming 

water temperature and, if it is not hot enough, the 

timer will be delayed for automatic water heating 

in the main wash of all cycles. This happens even 

when Hi-Temp option has not been selected. When 

Hi-Temp is selected, an even higher temperature 

will be guaranteed to handle heavier soil loads.

1.  Load dishwasher (See Preparing and Loading 

Dishes).

2.  Add detergent (See Dishwasher Dispenser &  

Detergents).

 3.  Add rinse aid, if needed (See Rinse Aid).

4.   Select desired Cycle (See Cycle Chart). The 

indicator light above the pad will glow when 

selected.

5.  Select desired Options (See Options). The 

indicator light above the pad will glow when 

selected.

6.   Close door to latch.

7.  Run hot water faucet nearest dishwasher until 

water is hot. Turn water off.

8.  To start, press Start/Cancel pad.
Note: The dishwasher is programmed to 

When the Sanitize option is selected, the Sanitized 

light will glow when the Sanitize cycle is finished. 

If the dishwasher did not properly sanitize the 

dishes, the light will not come on. This can happen 

if the cycle is interrupted. The light will remain on 

until the door is opened for 30 seconds.
The Clean light will come on at end of cycle and 

remain on until door is opened for 30 seconds.

Note: The time remaining could suddenly increase 

or drop several minutes. This means the turbidity 

sensor has checked the soil level and determined 

if additional water fills are needed or if water fills 

can be deleted.

1H-24………..  

Number of delay start hours. 

The last hour will count down in 

minutes.

MINUTES…...… 

Number of minutes left in cycle 

(1-99).