Frigidaire fgf379wesr Installation Instruction

a) Install an external manual gas shut-off valve to gas

supply line in an easily-accessible location outside of

the range. Be sure you know how and where to shut-

off the gas supply to the range.

b) Install 1/2" flare union adapter to pressure regulator.

c) Attach appliance conduit to flare union on regulator.

d) Install flare union adapter to external manual shut-off

valve.

e) Attach appliance conduit to flare union on shut-off

valve.

f) Make sure service shut-off valve on pressure regulator

is in "ON" position.

g) Check for leaks. Turn the gas supply on to the range and

use a liquid leak detector at all joints and conduits to

check for leaks in the system.

 Do not use a flame to check for gas leaks.

Disconnect the range and its individual shut-off valve from

the gas supply piping system during any pressure testing of

that system at test pressures greater than 14" of water

column pressure (approximately 1/2" psig).

The appliance must be isolated from the gas supply piping

system by closing its individual manual shut-off valve

during any pressure testing of the gas supply piping system

at test pressures equal to or less than 14" of water column

pressure (approximately 1/2" psig).

If it should be necessary to check the manifold gas pressure,

connect manometer (water gauge) or other pressure device

to the top burner right rear orifice.  Using a rubber hose

with inside diameter of approximately 1/4," hold tubing

down tight over orifice.  Turn burner valve on.

For an accurate pressure check have at least two (2) other

top burners burning. Be sure the gas supply (inlet) pressure

is at least one inch above specified range manifold pressure.

The gas supply pressure should never be over 14" water

column. When properly adjusted for Natural Gas the

manifold pressure is 4." (For LP/Propane Gas the manifold

pressure is 10.")

Electric Requirements:  An individual, properly grounded

and polarized branch circuit protected by a 15 amp. circuit

breaker or time delay fuse. See serial plate for proper

voltage.

Extension Cord Precautions:

Because of potential safety hazards under certain conditions,

we strongly recommend against the use of any extension

cord. However, if you still elect to use an extension cord, it

is absolutely necessary that it be a UL listed 3-wire grounding

type appliance extension cord and that the current carrying

rating of the cord in amperes be equivalent to or greater

than the branch circuit rating. Such extension cords are

obtainable through your local service organization.

 PLEASE READ CAREFULLY!  For personal

safety, this product must be properly grounded.

The power cord of this appliance is equipped with a

3-prong (grounding) plug which mates with a standard

3-prong grounding wall receptacle to minimize the

possibility of electric shock hazard from this appliance.  The

customer should have the wall receptacle and circuit checked

by a qualified electrician to make sure the receptacle is

properly grounded and polarized.

Where a standard two-prong wall receptacle is encountered,

it is the personal responsibility and obligation of the

customer to have it replaced with a properly grounded

three-prong wall receptacle.