Hamilton Beach 50110 User Guide

IMPORTANT: Your blender jar and
cutting blade assembly are subject to
wear during normal use. Always
inspect jar for nicks, chips, or cracks.
Always inspect cutting blade assem-
bly for broken, cracked, or loose
blades. If jar or cutting blade assem-
bly are damaged, do not use. Call
our toll-free customer service number
to obtain replacement parts.
The gasket is permanently attatched
to the cutting blade assembly. DO
NOT attempt to remove it.
1. Make sure blender is unplugged.

Place blender base on clean, dry
surface to keep foreign particles
from being pulled up into motor 
during operation.

2. Place cutting blade assembly in

the collar. Screw collar and cutting
blade assembly onto jar.

3. Make sure collar is firmly screwed

onto the jar. If not, it may loosen
later when motor is turned on.

4. Set jar into place on blender base,

making sure it is securely seated. 

5. Plug cord into outlet.
6. Put ingredients in jar; place lid

on jar. 

7. Process food or beverages. See

the “Blending Techniques” section
for speeds and processing tips.

8. ALWAYS turn blender off and

wait until blades have stopped
rotating before removing jar.

9. To remove jar after blending is

complete, lift the jar straight up. 

10. NEVER replace jar onto unit

while motor is running.

Fill blender jar with 1 cup (250 ml) of
ice cubes. Place lid on blender jar
then Pulse. Allow blades to come to a
complete stop between pulses.

Continue until ice is crushed to
desired consistency. 

• Processing hot foods or liquids in

the blender may cause hot liquid to
spurt out when the lid is removed.
Always remove the filler cap of the
cover before blending hot foods or
liquids. When blending hot liquids,
remove center piece of two-piece
lid. Do not fill blender jar beyond
the 3-cup (750 ml) level. Remove
filler cap and, with the protection of
an oven mitt or thick towel, place
hand on top of the blender jar lid
and hold down while blending.
Always begin processing at the
lowest speed setting. Ensure skin
and hands are covered to reduce
the risk of possible burns.

• To add foods when blender is oper-

ating, remove filler cap from lid and
add ingredients through the open-
ing.

• If blending action stops during 

blending or ingredients stick to
sides of the jar, turn blender Off / O.
Remove lid and use a rubber spatu-
la to push mixture toward blades.

• Do not try to mash potatoes, mix

stiff dough, whip egg whites, grind
raw meat, or extract juices from
fruits and vegetables. The blender
is not made to perform these tasks.

• Do not store food or liquids in the

blender jar.

• Moisten lip of lid to facilitate 

placing lid on jar.

840152000 ENv02.qxd  6/26/06  1:42 PM  Page 7