Microtek 120tf Reference Manual

Reference:  The Preview window          11

The Scanner Driver Manager keeps track of the scanners being used on your
system and their corresponding bus/ID numbers. By keeping a record of this
information, the Scanner Driver Manager allows ScanWizard Pro TX to start up
faster, as searching for devices from other buses is no longer required.

When ScanWizard Pro TX is run for the first time right after installation, all pre-
connected powered-on scanners and corresponding SCSI/USB ID or SCSI/USB
bus are automatically detected and added to the Scanner List of the Scanner
Driver Manager dialog box.

Whenever you change the SCSI/USB ID or SCSI/USB bus of a scanner or
increase the number of connected scanners while ScanWizard Pro TX is
running, you need to add the new devices to the list by following the steps below.

1. Go to the Scanner menu in the Preview window, and choose Scanner Driver

Manager. A dialog box will appear showing the current scanner list and the
corresponding SCSI or USB bus/ID numbers of the scanners.

2. Click the Find Scanners button. Observe the newly found scanners being

appended to the scanner list.

NOTE::::: Any previously listed scanner which is inactive (not turned on or removed
from the system) will remain in the list but is shown with a question mark (?).

3. Click the Close button to close the dialog box.