Microtek 2020 User Manual

1. In Windows NT, click on the Start menu, go to

Programs, Administrative Tools (Common),
and select Windows NT Diagnostics. This will
bring you to the following partial screen shot:

2. Click on the Resources tab to bring up the

following screen:

At this screen you see a list of IRQs that are
currently in use. By clicking on the I/O Port
button at the bottom of the screen, you can see
a list of I/O addresses that are in use.

Installation under Windows NT 4.0

If you are using Windows NT 3.51, refer to the
document For Windows NT 3.51 in the folder
Microtek ScanWizard Pro for Windows in the
Programs menu. To install under Windows NT 4.0,
take the steps below:

1. Reset the scanner's SCSI ID if necessary

2. Install the interface card in your computer

3. Check your Windows NT configuration

4. Install software

5. Connect the scanner and computer

6. Test your scanner

Part of the above procedures, especially to
hardware installation should refer to the previous
pages (Installation under Windows 95 section).
Descriptions below follow installation sequence,
but concentrated on Windows NT 4.0

1. Resetting the scanner's SCSI ID

if necessary

You may or may not need to change the SCSI ID on
your scanner. For more details on how to reset
your scanner’s SCSI ID, refer to Step 4 on page 5.

2. Installing the interface card

Before installing the interface card supplied with
your scanner, make sure you have turned off your
computer and peripherals. Then refer to Step 1 on
page 2.

3. Checking your Windows NT

configuration

When you run Windows NT, the Adaptec AVA-
2903E SCSI Host Adapter is detected and the
driver is automatically installed. Follow the steps
below to check.

The “aic78xx”
message
indicates you
are using
AVA-2903E
SCSI interface
card.

Number 05
appears,
indicating IRQ
5 is in use.

This I/O
address is
used by
AVA-2903E
interface card.

I/O Port
button.

e_2815body.p65

11/9/00, 4:53 PM