Microtek 997m User Guide
21
press the bottom (or top) Adjustment Control button until the
lines disappear and you have a clear display.
lines disappear and you have a clear display.
PROBLEM: There is no LCD Display
If there is no display on the LCD, please perform the following steps:
1. Make sure that the power indicator on the LCD Monitor is lit,
all connections are secure, and the system is running on the
correct timing. Refer to the Appendix B for information on
timing.
correct timing. Refer to the Appendix B for information on
timing.
2. Turn off the LCD Monitor and then turn it back on again.
Press the upper Function Control button (refer to Chapter 2)
once and then press either the upper or lower Adjustment
Control button several times. If there is still no display, press
the other Adjustment Control button several times.
once and then press either the upper or lower Adjustment
Control button several times. If there is still no display, press
the other Adjustment Control button several times.
3. If step 2 does not work, connect your PC system to another
external CRT. If your PC System functions properly with a
CRT Monitor but it does not function with the LCD Monitor,
and the LCD Monitor’s power LED is blinking, the output
timing of the PC’s VGA card may be out of the LCD’s
synchronous range. Please change to an alternate mode
listed in Appendix B, or replace the VGA card and repeat
steps 1 and 2.
CRT Monitor but it does not function with the LCD Monitor,
and the LCD Monitor’s power LED is blinking, the output
timing of the PC’s VGA card may be out of the LCD’s
synchronous range. Please change to an alternate mode
listed in Appendix B, or replace the VGA card and repeat
steps 1 and 2.
4. If the PC does not function with the CRT monitor as well,
check the BIOS to see if there is a dual scan setting under
the display mode item. Set the BIOS display mode to Dual
Scan or CRT and try again. If there is still no display, then
there may be a problem with your system. Contact technical
support.
the display mode item. Set the BIOS display mode to Dual
Scan or CRT and try again. If there is still no display, then
there may be a problem with your system. Contact technical
support.
5. If the power LED is not lit, check to see if the AC power
connector is securely connected. Verify that the AC adapter
LED is lit. If the AC adapter LED is not lit, please contact
your dealer for assistance.
LED is lit. If the AC adapter LED is not lit, please contact
your dealer for assistance.