Microtek 1000xl User Guide
ScanMaker 1000XL Supplement 11
B. Using the 35mm Filmstrip Template
To scan 35mm filmstrips, use the 35mm Filmstrip Template, which can simultaneously
hold two strips of 6 frames each, or a total of 12 frames.
hold two strips of 6 frames each, or a total of 12 frames.
1. Place the 35mm filmstrip to be scanned inside the frame of the 35mm Filmstrip
Template. The shiny base of the 35mm filmstrip should be facing down, and the
emulsion side of the filmstrip should be facing up.
emulsion side of the filmstrip should be facing up.
2. Place the 35mm Filmstrip Template containing the loaded filmstrip on the
scanner glass surface. Make sure to orient the template with the “Microtek”
logo facing up.
logo facing up.
Orient template with
"Microtek" logo facing up
"Microtek" logo facing up
Align the edge of the film frame
with the arrow mark of the template
with the arrow mark of the template
2
1
0
3
4
5
6
6
5
4
3
2
1
The Grabber is used to remove the
template out of the scanner glass
surface.
template out of the scanner glass
surface.
Important: Align the template's
front corners firmly against the top
corners (left and right) of the
U-shaped ruler located at the front
of the scanner. During placement of
the template, make sure that the
calibration strip on the scanner
glass surface is kept clear and free
of obstruction at all times.
front corners firmly against the top
corners (left and right) of the
U-shaped ruler located at the front
of the scanner. During placement of
the template, make sure that the
calibration strip on the scanner
glass surface is kept clear and free
of obstruction at all times.
Calibration strip
Microtek logo