Microtek 3700 Installation Instruction

I49-002920, August 2000

http://www.microtek.com

1. Unpack scanner

Open your scanner package and check major components
while referring to the Packing List. If any item is missing,
contact Microtek Customer Service.

Your Microtek ScanMaker 5700 scanner comes with
FireWire

FireWire

FireWire and USB

USB

USB built-in interfaces. See the figure below

to locate the different ports at the back panel of the
scanner, including the scanner's accessory port.

2. Unlock the carriage

1. With the scanner turned off, tilt the scanner on its side

to locate the carriage lever safety lock (located at the
bottom left side).

2. Slightly pull the lever towards you until you hear a

“click” which indicates that the scanner carriage has
been unlocked.

Installing and
Getting Started

for the ScanMaker

5700

Version

FireWire - Windows 98 SE, Windows Me,

Windows 2000, Mac G3/G4 and iMac DV

USB - Windows 98, Windows Me,

Windows 2000, Mac G3/G4 and iMac

Version

This document provides information on how to install your Microtek scanner on a PC or Mac using the scanner's
FireWire or USB interface and describes the features of the scanning.

Trademarks
Microtek

, ScanMaker

, ScanWizard

, FilmView

are registered trademarks of Microtek International Inc. Macintosh

, Apple

, FireWire

and FireWire logo are trademarks or

registered trademarks of Apple Computer, Inc. Windows

is a registered trademark of Microsoft Corporation. All other products or name brands are trademarks of their respective

holders.

Power
switch

Installation for PC and Macintosh

Pull to unlock
carriage safety lock

FireWire ports

Power port

Accessory port

USB port