Microtek 1000xl Supplementary Manual

ScanMaker i900 Supplement     33

After the Preview, you are now ready to complete calibration and create a profile for
your scanner.

1. Scan the target. To do this, select the entire target by dragging a frame over it, and

then click the Next>> button.

2. Align the registration marks of the target with your cursor (see inset at bottom

of page).

3. Click the Create Profile button (PC) or Finish button (Mac)  to create the scanner

ICC profile. At the end of the profiling process, a dialog box appears, prompting
you to enter a profile name and description.

After the upper left mark is aligned,
the upper right part of the target image
is displayed, and an instruction dialog
box prompts you to align the upper
right registration mark.
Move the cursor to the target image
area; the pointer will change to a
normal L mark (“   ”). Align the cursor
with the small upper-right registration
mark.

Move the cursor to the target image
area; the pointer will change to a
horizontally flipped L mark (“   ”).
Align the cursor with the small upper-
left registration mark.

After the upper right mark is aligned,
the lower right part of the target
image is displayed, and an instruction
dialog box prompts you to align the
bottom-right registration mark.
Move the cursor to the target image
area; the pointer will change to a
vertically flipped L mark (“   ”). Align
the cursor with the small bottom-
right registration mark.

A. Upper-left registration mark

B. Upper-right registration mark

C. Bottom-right registration mark