Sima wx-268 User Manual

The WX-268 Public Alert radio is equipped to connect a variety of special needs

accessory devices including strobe lights, pillow vibration modules and remote sirens.

 Once connected, these devices will automatically be activated when the radio

receives an advisory, watch or warning for the duration of the radio siren or until you
press the Radio OFF button.

To connect a  special needs accessory,

plug the device into the Remote Alert jack
on the rear panel of the radio shown in Fig.
1. This jack requires a 3.5 mm connector.

Note: If an alert is blocked, the

accessory will not be activated. The Alert
Volume switch does not affect devices
connected to the remote alert ouput.

Fig. 1

1. Remove the wall mount bracket from the package. Hold the bracket at the mounting

location with the narrow edge at the top. Use it as a template
to mark the positions for the screw holes on the wall or other
mounting surfaces.

2. Drill two screw holes and fix the screws onto the wall, using

the drywall anchors if necessary.  Leave a space of about
3mm (1/8”) between the head of the screw and the wall.

3. Put the radio and the wall mount bracket together with the AC

adapter plug installed. Make sure all the clips are properly
set and the radio is secured.

4. Hang the radio with the wall mount onto the two screws on

the wall, make sure the installation is secure.  Connect the
AC adapter to a power outlet to activate the radio.