Novation remote25sl User Guide

• 

14

•

The screen display when a control moved is slightly different for buttons using MMC :

Stop
1   MMC   1 U12

This is similar to the normal display shown when other types of MIDI information are transmitted, except
that the top line displays the type of MMC command defined, while the bottom line at the left is the MMC
number of the command defined for the button.

Only buttons can be assigned to send MMC. When MMC is used, there is no Control name used or dis-
played.

The screen shows NOTE. There is no controller number 
displayed.

The screen shows SYSEX. There is no controller number 
displayed.

The screen shows PROGC. There is no controller number 
displayed.

The screen shows PBEND. There is no controller number 
displayed.

Sending a Snapshot of the controls

It is possible to send a snapshot of current values to a connected MIDI device by pressing the F1 / SNAP-
SHOT button while in Play Mode. 

The data values sent are the ones stored for each control in the Template data, (except for where a control
has been moved) since the Template has been loaded. If a control has been moved, the new value repre-
sented by the position of the altered control is sent instead of the stored value.

Be aware that, when a snapshot is sent, the current position of a control might not bear any relation
to the data value sent in the snapshot if that control has not been touched since the Template was
selected.

For each control, the snapshot data is sent from whatever USB / MIDI port as defined for the control in the
Template data. Any MMC functions assigned to buttons are not sent in a snapshot.

It is possible for any Template to be set to automatically send a snapshot as soon as the ReMOTE 25 is
placed into Play Mode. See page 26 for details.