Nortel 1110 User Guide

 Nortel IP Phone 2002

553-3001-368 Standard 26.00 August 2007

To edit network configuration the following soft keys are available:

•

OK—accept current settings and proceed to the next configuration 
option. If all configuration options are presented, the configuration is 
saved and the IP Phone reboots with the saved changes.

•

BkSpace—backspace a configuration entry to change it

•

Clear—clear an entire configuration entry

•

Cancel—cancels out of network configuration. The IP Phone reboots 
without saving changes.

At the prompt EAP Enable?, enter 1-Yes (1 for Yes) if the network 
infrastructure supports 802.1x port-based network access control. Enter 
DeviceID and Password. 

If you select No, you are not prompted to enter Device ID and Password.

For more information on EAP, see Appendix Appendix C:: “802.1x Port-
based network access control” on 

.

At the prompt, LLDP Enable?, enter 1-Y (1 for Yes, default), or 0-N (0 for 
No).

For more information about LLDP, see Appendix Appendix D:: “802.1ab 
Link Layer Discovery Protocol” on 

.

Timing information
There are only four seconds (s) between plugging in the IP Phone 2002 
power transformer and the appearance of the Nortel logo in the middle 
of the display. When you see the logo, you have one s to respond by 
pressing the four soft keys at the bottom of the display in sequence from 
left to right, one at a time. If you miss the one-s response time, the 
IP Phone 2002 attempts to locate the connect server. You can begin the 
power-up sequence again, or you can double-press the Services key to 
open the network diagnostic utilities to access the IP Phone settings. 
See Appendix Appendix E:: “IP Phone diagnostic utilities” on