Nortel 1110 User Guide

 Nortel IP Phone 1110

IP Phones

Description, Installation, and Operation

•

Ensure the host Call Server is equipped with the Voice Gateway Media 
Card, or a Signaling Server with the Line TPS application.

•

If an AC power adapter is required, ensure the approved Nortel AC 
adapter (model # N0089601) is used. See Table 37, “IP Phone 1110 
components list,” on page 316.

You must first install an IP telephony node with the Communication Server. 
For information about installing an IP telephony node, see Signaling Server: 
Installation and Configuration (553-3001-212), or IP Line: Description, 
Installation, and Operation  (553-3001-365).

You must configure the IP Phone 1110 before you can use it. Use 
Procedure 57 to configure the IP Phone 1110 for the first time. 

Configure a virtual loop on the Call Server using LD 97.

For more information about configuring a virtual loop, see IP Line: 
Description, Installation, and Operation  (553-3001-365), and Software 
Input/Output: Administration (553-3001-311).

Configure the IP Phone 1110 on the Call Server as IP Phone 2001 using 
LD 11. At the prompt, enter the following:

REQ:chg

TYPE:2001

Damage to Equipment
Do not plug your IP Phone 1110 into an ISDN 
connection. Severe damage can result.