Nortel 1110 User Guide
Nortel IP Phone 1110
Page 325 of 630
IP Phones
Description, Installation, and Operation
7
If you are connecting your PC through the phone, you will require a
second CAT5 cable. Only one cable is included with the IP Phone 1110
package. Connect one end of the PC Ethernet cable to your phone using
the CAT5 connector marked with the symbol
second CAT5 cable. Only one cable is included with the IP Phone 1110
package. Connect one end of the PC Ethernet cable to your phone using
the CAT5 connector marked with the symbol
(
, and thread it through the
channel marked with the symbol
(
. Connect the other end to the LAN
connector on the back of your PC.
Note: Complete steps 1-9, as needed, before wall-mounting the
IP Phone.
IP Phone.
8
Wall-mount your phone (optional). Use Method A or Method B to wall-
mount the IP Phone. See Method A—using the mounting holes on the
bottom of the phone stand, or Method B—using the traditional-style wall-
mount box with a CAT5 connector and a 15 cm (6 inch) CAT5 cord (not
provided). See Figure 29 on
mount the IP Phone. See Method A—using the mounting holes on the
bottom of the phone stand, or Method B—using the traditional-style wall-
mount box with a CAT5 connector and a 15 cm (6 inch) CAT5 cord (not
provided). See Figure 29 on
.
•
Method A: Press the wall-mount lever, and pull away from the stand.
Using the stand cover (see step 3 on
Using the stand cover (see step 3 on
), mark the wall-mount
holes by pressing the bottom of the stand cover firmly against the wall
in the location where you wish to install the phone. Four small pins on
the bottom of the stand cover make the marks on the wall. Use the
marks as a guideline for installing the wall-mount screws (not
provided).
in the location where you wish to install the phone. Four small pins on
the bottom of the stand cover make the marks on the wall. Use the
marks as a guideline for installing the wall-mount screws (not
provided).
Install the screws so that they protrude 3 mm (1/8 inch) from the wall,
and then install the phone stand mounting holes over the screw
heads. You may need to remove the phone from the wall to adjust the
lower screws. When the lower screws are snug, install the phone on
the mounting screws, and then tighten the top screws.
and then install the phone stand mounting holes over the screw
heads. You may need to remove the phone from the wall to adjust the
lower screws. When the lower screws are snug, install the phone on
the mounting screws, and then tighten the top screws.
•
Method B: Attach the 15 cm (6 inch) CAT5 cable (not provided),
position the stand over the mounting rivets, and slide the phone down
the wall so that the rivets fit into the slots on the stand.
position the stand over the mounting rivets, and slide the phone down
the wall so that the rivets fit into the slots on the stand.
9
Replace the stand cover. Ensure that all cables are neatly routed and
press the stand cover into place until you hear a click.
press the stand cover into place until you hear a click.
CAUTION
Damage to Equipment
Do not plug any device into your IP Phone 1110
Ethernet port other than one PC. The IP Phone 1110
does not support multiple devices connected through
the PC Ethernet Port.
Do not plug any device into your IP Phone 1110
Ethernet port other than one PC. The IP Phone 1110
does not support multiple devices connected through
the PC Ethernet Port.