Nortel 1110 User Guide
Page 370 of 630
Nortel IP Phone 1120E
553-3001-368 Standard 26.00 August 2007
7
If you are connecting your PC through the phone, you will require a
second CAT5 cable. Only one cable is included with the IP Phone 1120E
package. Install the Ethernet cable connecting the PC to the phone
(optional). Connect one end of the PC Ethernet cable to your phone using
the RJ-45 connector marked with the symbol
second CAT5 cable. Only one cable is included with the IP Phone 1120E
package. Install the Ethernet cable connecting the PC to the phone
(optional). Connect one end of the PC Ethernet cable to your phone using
the RJ-45 connector marked with the symbol
(
, and thread it through the
channel marked with the symbol
(
. Connect the other end to the LAN
connector on the back of your PC.
8
Install additional cables. If applicable, plug in optional USB devices.
Connect the Ethernet cable to the LAN Ethernet connection. If you are
using an AC power adapter, plug the adapter into an AC outlet.
Connect the Ethernet cable to the LAN Ethernet connection. If you are
using an AC power adapter, plug the adapter into an AC outlet.
Note: Complete steps 1-9, as needed, before wall-mounting the
IP Phone.
IP Phone.
9
Wall-mount your phone (optional). Use Method A or Method B to wall-
mount the IP Phone. See Method A—using the mounting holes on the
bottom of the phone stand, or Method B—using the traditional-style wall-
mount box with a RJ-45 connector and a 15 cm (6 inch) RJ-45 cord (not
provided).
mount the IP Phone. See Method A—using the mounting holes on the
bottom of the phone stand, or Method B—using the traditional-style wall-
mount box with a RJ-45 connector and a 15 cm (6 inch) RJ-45 cord (not
provided).
•
Method A: Press the wall-mount lever, and pull away from the stand.
Using the stand cover (see step 3 on
Using the stand cover (see step 3 on
), mark the wall-mount
holes by pressing the bottom of the stand cover firmly against the wall
in the location where you wish to install the phone. Four small pins on
the bottom of the stand cover make the marks on the wall. Use the
marks as a guideline for installing the wall-mount screws (not
provided).
in the location where you wish to install the phone. Four small pins on
the bottom of the stand cover make the marks on the wall. Use the
marks as a guideline for installing the wall-mount screws (not
provided).
Install the screws so that they protrude 3 mm (1/8 inch) from the wall,
and then install the phone stand mounting holes over the screw
heads. You may need to remove the phone from the wall to adjust the
lower screws. When the lower screws are snug, install the phone on
the mounting screws, and then tighten the top screws.
and then install the phone stand mounting holes over the screw
heads. You may need to remove the phone from the wall to adjust the
lower screws. When the lower screws are snug, install the phone on
the mounting screws, and then tighten the top screws.
•
Method B: Attach the 15 cm (6 inch) CAT5e cable, position the stand
over the mounting rivets, and slide the phone down the wall so that
the rivets fit into the slots on the stand.
over the mounting rivets, and slide the phone down the wall so that
the rivets fit into the slots on the stand.
CAUTION
Damage to Equipment
Do not plug any device into your IP Phone 1120E PC
Ethernet port other than a PC.
Do not plug any device into your IP Phone 1120E PC
Ethernet port other than a PC.