Nortel 1110 User Guide
148
Nortel IP Audio Conference Phone 2033
outlet voltage. See
or
First-time installation
You must first install an IP telephony node with the Communication Server.
For information about installing an IP telephony node, see Signaling Server
Installation and Commissioning (NN43001-312), or IP Line Fundamentals
(NN43100-500).
For information about installing an IP telephony node, see Signaling Server
Installation and Commissioning (NN43001-312), or IP Line Fundamentals
(NN43100-500).
CAUTION
Service Interruption
Do not plug your IP Audio Conference Phone 2033 into an ISDN
connection. Severe damage can result.
connection. Severe damage can result.
Configuring the IP Audio Conference Phone 2033
Use
to configure the IP Phone 2001 for the first time
Procedure 25
Configuring the IP Audio Conference Phone 2033
Step
Action
1
Configure a virtual loop on the system using LD 97.
For more information about configuring a virtual loop, see IP
Line Fundamentals (NN43100-500) and Software Input Output
Administration (NN43001-611).
Line Fundamentals (NN43100-500) and Software Input Output
Administration (NN43001-611).
2
Configure the IP Audio Conference Phone 2033 on the system using
LD 11. At the prompts, enter the following:
LD 11. At the prompts, enter the following:
REQ:chg
TYPE:2033
TN cc uu
ECHG yes
ITEM cls
ITEM
For more information about configuring the IP Audio Conference
Phone 2033 using LD 11, see Software Input Output Administration
(NN43001-611).
Phone 2033 using LD 11, see Software Input Output Administration
(NN43001-611).
3
Connect one end of the CAT5 Ethernet cable to the network interface
located on the back of the Power over Ethernet (PoE) module. See
located on the back of the Power over Ethernet (PoE) module. See
. Plug the other end of the CAT5
Ethernet cable into your IP network interface.
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368
01.02
Standard
Release 5.0
20 June 2007
Copyright © 2003–2007, Nortel Networks
.