Nortel 1110 User Guide
Installation
423
Figure 53
Connecting the Expansion Module
Connecting the Expansion Module
4
If connecting a second, or a third Expansion Module, repeat steps
2 to 4.
2 to 4.
The second Expansion Module is attached to the right side of the
first Expansion Module. The third Expansion Module is attached to
the right side of the second Expansion Module.
first Expansion Module. The third Expansion Module is attached to
the right side of the second Expansion Module.
5
Adjust the height of the IP Phone tilt adjustment to a comfortable
viewing angle. Then adjust each of the Expansion Module footstands
so they are flush to the desk surface. Turn the wheel on the back
right side of the Expansion Module to the right (if viewed from the
front) to tighten the Expansion Module.
viewing angle. Then adjust each of the Expansion Module footstands
so they are flush to the desk surface. Turn the wheel on the back
right side of the Expansion Module to the right (if viewed from the
front) to tighten the Expansion Module.
CAUTION
Do not over tighten the wheel on the Expansion Module.
6
Connect power to the IP Phone. The Expansion Module powers up.
The Expansion Module uses the electrical connection of the IP
Phone for power. It does not have its own power source.
Phone for power. It does not have its own power source.
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368
01.02
Standard
Release 5.0
20 June 2007
Copyright © 2003–2007, Nortel Networks
.