Optoma hd8000-lv User Guide

18

Using the Remote Control

Refer to the “Power On/Off the Projector” 

section on pages 13-14.

 Brightness 

Adjust the brightness of the image.

Control the degree of difference between 

the lightest and darkest parts of the picture.

Switch the Image AI function ON/OFF. 

(refer to page 32-33) 

There are 10 preset gamma curves.  After 

the initial setup and fine tuning is complet-

ed, utilize the Gamma Adjustment steps to 

optimize your image output.

Refer to “IRIS” function on page 33 for 

more information.

Increase the brightness of the image. (refer 

to page 35).

Shifts the projected image position verti-

cally.

Choose “On” to mask off a few pixels on 

each edge of the image to be displayed.  Use 

Edge Mask “On” if image source happens 

to have encoding error near any edge of the 

displayable image.

Select the display mode from Cinema, 

Bright, TV, sRGB and User.

Press “Menu” to launch the on-screen 

display (OSD) menu. To exit OSD, Press 

”Menu” again.

Use         to select items or make adjust-

ments to your selection.

Confirm your item selection.

Mask off a few pixels on each edge of the 

image to be displayed. Use this function 

to adjust if image source happens to have 

noise near any edge of the display image.

Scale the image at a 4:3 aspect ratio.