Rimage 480i Reference Guide

Page of 4
Rimage Desktop Family™ 
 
Operator 
 
2000558_B 
© 2007, Rimage Corporation 
 
Replace the Printer Platform on a Rimage 2000i or Standalone 480i Printer 
Use this procedure to replace the printer platform on a Rimage 2000i™ or Standalone 480i™ Printer
Rimage approved parts must be used for this process. The product warranty may become void if parts not approved by Rimage are 
used; equipment or parts are tampered with, misused, neglected, or modified in any respect without the written consent of Rimage.
 
Note: Your system may not look exactly like the system pictured. 
Before you begin  
1.  Stop or pause all jobs. 
2.  If the printer is on an autoloader, power off the 
autoloader
3. Disconnect 
the 
power cord from the power outlet. 
# 
Required tools: 
• 
Torx T10 screwdriver 
 
Remove the Printer Platform 
1. Disconnect 
the 
cables
Caution! Some cables in this system are latched. Equipment damage may occur if cables are not 
disconnected appropriately. 
ble (if present, 2000i only) 
• 
FireWire ca
• 
USB cable 
• 
Power cord 
2000i 
 
Standalone 480i Printer 
 
USB Cable  
Printer 
Service 
Door 
Printer 
Service 
Door 
USB Cable  
 
2. Open 
the 
printer service door
 
Tip: Press the tab to free the printer service 
door from the frame. 
 
3.  Remove the rear Torx T10 screws (Qty. 2) from 
the printer platform. 
Note: The printer platform is the metal plate 
on top of the sliding printer tray. 
 
 
 
Printer 
Servic
Door 
Powe
Cord 
FireWire 
Cable 
(if present) 
Power 
Cord 
Tab 
Printer 
Platform 
Printer 
Tray