Rimage prism Reference Guide

This is an emergency system recovery process and should be used to recover the system’s 
default configuration. 

- 

Important: Ensure there are no other embedded Rimage AutoLoaders named 
RimageProducer3 actively running on the network. 

Note: If this unit is not attached to a network, a monitor, mouse and keyboard must be 
connected to the back of the embedded unit

. 

1.  With the unit powered on: 

a. Insert 

the 

Recovery Disc in the recorder tray marked Drive 1 (top drive). 

b.  Press and hold the PC power button on the front of the unit until the unit powers off. 

c. Press 

the 

PC power button again to power on the unit.  

2.  The application starts automatically and recovery begins.  

3.  When the operator panel displays REMOVE DISC THEN REBOOT SYSTEM (approximately 

10 minutes): 

a.  Remove the recovery disc from the recorder tray. 

b.  Press and hold the PC power button until the unit powers off. 

c. Press 

the 

PC power button again to power on the unit. The system initializes. 

4.  Watch the operator panel for the prompt: REMOTE LOGON TO: RIMAGEPRODUCER3 

(approximately 5 minutes). 

 Note: You cannot log on until the system fully initializes. This may take several more 

minutes. 

5.  Log on to the system: 

• 

If the unit is attached to a network, log on to the system using Remote Desktop 
Connection on a separate computer.  

 Note: See the Rimage Advanced Setup Guide for instructions on accessing the 

Remote Desktop Connection. 

Computer: RimageProducer3 

User Name: Administrator 

Password: password 

 Note: The Password is case sensitive. 

Domain: leave blank 

• 

If the unit is not attached to a network, log on using the attached monitor, mouse and 
keyboard. 

6. Change 

the 

computer name (optional). See the Rimage Advanced Setup Guide for 

instructions. 

2000027_A 1