Sony kdl-55nx720 User Guide

D:\Cmeng's JOB\SONY TV\SY0390_W4 (Rev-4)\4270401131_US\US04SAF.fm

KDL-60/55/46NX720/55/46HX820/XBR-65/55/46HX929

4-270-401-13(1)

Your remote control can be programmed to use other equipment and is pre-programmed to 
operate the following Sony equipment.

If you can turn your equipment on and off using the green POWER button, the 
programming is complete. If not, try the next code listed.

~
• In some cases, you may not be able to program your remote control. If this is the case, use your 

equipment’s own remote control.

• Any of the function buttons (DVD, AMP, STB) can be programmed to operate other equipment 

regardless of the labeling. For example, if programmed with the correct code, a Blu-ray Disc player 
can be operated with the DVD button. This is useful if your equipment does not match any of the 
labeled buttons.

Press SCENE, TV "/1 (TV POWER), and 

 simultaneously. The four function buttons 

(DVD, AMP, STB, and TV) blink when successfully reset.

DVD

DVD Player

31033 

AMP

Receiver

52172 

STB

Digital Satellite

01639

Follow the steps below to program your TV remote control.

1 Look for the code in the Manufacturer’s Code List (refer to 

i-Manual) that corresponds to the equipment you would like to 
operate with the Sony remote control. If more than one code is 
provided, try programming the first code listed. If your 
equipment’s code is not listed, visit 
http://esupport.sony.com/remotecodes for a more comprehensive 
list.

2 Press and hold DVD, AMP or STB function button 

simultaneously with t button and release.
When in the programming mode, the function button (DVD, 
AMP, STB) blinks for approximately 30 seconds until a code is 
entered.

3 Enter the five digit code using 

 - 

 while the function 

buttons (DVD, AMP, STB) are lit. If the code is not entered 
within 30 seconds, you must repeat step 2.

4 Press 

 to confirm the code. If successfully programmed, the 

function button (DVD, AMP, STB) will blink twice, if not, it 
blinks five times.