Extreme x250e-24t Installation Instruction
Installing Summit External Power Supplies
Summit Family Switches Hardware Installation Guide
136
CAUTION
Do not use the rack-mount brackets to suspend the EPS-T2 from under a table top or desk, or to attach the EPS-T2
to a wall.
to a wall.
Rack-mounting the EPS-T2
To install the EPS-T2:
1
Place the EPS-T2 upright on a secure surface, with the front facing you.
2
Remove the mounting bracket kit from the packaging.
3
Attach the mounting brackets as follows:
a
Place a mounting bracket over the mounting holes on one side of the EPS-T2 (see
).
b
Insert the provided screws and fully tighten with a screwdriver.
Figure 104: Attaching the Mounting Bracket
c
Repeat steps
4
Slide the EPS-T2 into a 19-inch rack and secure it using appropriate rack-mount screws.
Installing an EPS-150DC Power Supply
NOTE
Install the EPS-T2 before you begin installing the EPS-150DC.
WARNING!
Always be sure that the DC circuit is de-energized before connecting or disconnecting the DC wiring harness at the
DC power socket on the rear of the EPS-150DC unit, and before connecting or disconnecting the redundant power
cord between the switch and the EPS-150DC unit.
DC power socket on the rear of the EPS-150DC unit, and before connecting or disconnecting the redundant power
cord between the switch and the EPS-150DC unit.
Installing an EPS-150DC unit consists of the following tasks:
●
Connecting the DC wiring harness to the DC source voltage (see
).
This task must be performed by a licensed, qualified electrician.
ES4K026