Extreme x250e-24t Installation Instruction
Summit Family Switches Hardware Installation Guide
169
Maintenance Safety
When you perform maintenance procedures on Extreme Networks equipment, follow these
recommendations:
recommendations:
●
Use only original accessories or components approved for use with this system. Failure to follow
these instructions may damage the equipment or violate required safety and EMC regulations.
these instructions may damage the equipment or violate required safety and EMC regulations.
●
The chassis cover should only be removed by Extreme Networks personnel. This system contains no
customer serviceable components. Repairs to the system must be performed by an Extreme
Networks factory service technician.
customer serviceable components. Repairs to the system must be performed by an Extreme
Networks factory service technician.
●
In systems that have power-on buttons, the power on button may not turn off all system power. To
remove power from the system, you must unplug all power cords from wall outlets. The power cord
is the disconnect device to the main power source.
remove power from the system, you must unplug all power cords from wall outlets. The power cord
is the disconnect device to the main power source.
●
Disconnect all power cords before working near power supplies, unless otherwise instructed by a
maintenance procedure.
maintenance procedure.
●
Replace a power cord immediately if it shows any signs of damage.
●
When you work with optical devices, power supplies, or other modular accessories, put on an ESD-
preventive wrist strap to reduce the risk of electronic damage to the equipment. Connect the other
end of the strap to an appropriate grounding point on the equipment rack. Leave the ESD-preventive
wrist strap permanently attached to the equipment rack so that it is always available when you need
to handle ESD-sensitive components.
preventive wrist strap to reduce the risk of electronic damage to the equipment. Connect the other
end of the strap to an appropriate grounding point on the equipment rack. Leave the ESD-preventive
wrist strap permanently attached to the equipment rack so that it is always available when you need
to handle ESD-sensitive components.
●
Install all cables in a manner that avoids strain. Use tie wraps or other strain relief devices.
General Safety Precautions
Follow these guidelines:
●
Do not try to lift objects that you think are too heavy for you.
●
When you install equipment in a rack, load heavier devices in the lower half of the rack first to
avoid making the rack top-heavy.
avoid making the rack top-heavy.
●
For Summit desktop equipment installations, do not place a monitor or other objects on top of the
equipment. The chassis cover is not designed to support weight.
equipment. The chassis cover is not designed to support weight.
●
Only use tools and equipment that are in perfect condition. Do not use equipment with visible
damage.
damage.
●
Route cables in a manner that prevents possible damage to the cables and avoids causing accidents,
such as tripping.
such as tripping.
Cable Routing for LAN Systems
The Summit family switches meet the requirements for LAN system equipment. LAN systems are
designed only for intra-building installations; that is, cable runs between devices must be in the same
building as the connected units.
designed only for intra-building installations; that is, cable runs between devices must be in the same
building as the connected units.