Extreme 3802 Installation Guide

202

Extreme Networks Consolidated "i" and "e" Series Hardware Installation Guide

Figure 115 shows the WM-1T3i module.

Figure 115: WM-1T3i module

The WM-1T3i module has one T3 port, consisting of two BNC connectors, one for the transmit path and 
one for the receive path. The module also has two general purpose 10/100 Ethernet ports, using 
standard RJ-45 connectors. The WM-1T3i also has eight internal loopback ports that allow you to 
configure bi-directional rate-limiting without tying up any of the external ports for ingress rate shaping. 
Internal loopback ports are marked with the notation “iL” when displayed on the command line or 
with ExtremeWare Vista Web access.

For the WM-1T3i module, use RG-59 75 ohm coaxial cable.

The WM-1T3i module has the following LEDs:

Module status

Port status

For information about the LEDs and their activity on the WM-1T3i module, see “I/O Module LEDs” on 
page 202.

The WM-1T3i module requires ExtremeWare version 6.1.5 or later and BootROM 6.5 or later. 

For more information about software requirements and WM-1T3i module configuration, see the 
ExtremeWare Software User Guide and the ExtremeWare Command Reference Guide. 

Table 40 describes the LED activity on the Alpine I/O modules with the green stripe (for example, the 
GM-4Ti, GM-4Xi, and FM-24MFi I/O modules).

Table 40: Alpine I/O module LEDs (green stripe)

Status

Green 

Amber 

Off

Normal operation

Disabled

No power

38_WM1T3i

10/100 Mbps ports

Module status

LEDs

T3 port

Module reset button