Extreme 3802 Installation Guide
380
Extreme Networks Consolidated "i" and "e" Series Hardware Installation Guide
Installing the Summit Option Card and XENPAK Modules
CAUTION
The XENPAK module can emit invisible laser radiation. Avoid direct eye exposure to the beam when
fiber optic connections are unplugged.
fiber optic connections are unplugged.
NOTE
Compliance Information: Compliant with EN60825-1+A2:2001 for European Union; Compliant with FCC
21 CFR Chapter 1, Subpart; Class 1 Laser Product; Refer to switch or I/O module specific
documentation for further compliance information when this optic device is installed within a system.
21 CFR Chapter 1, Subpart; Class 1 Laser Product; Refer to switch or I/O module specific
documentation for further compliance information when this optic device is installed within a system.
WARNING!
To prevent ESD damage to the Summit 400-48t, always use an ESD-preventive wrist strap when
installing or removing the module. Handle the module by its sides only. Never touch the card-edge
connectors at the insertion end of the module.
installing or removing the module. Handle the module by its sides only. Never touch the card-edge
connectors at the insertion end of the module.
To install XENPAK modules:
1
Hold the module by its sides and insert it into one of the two slots on the Summit option card
(Figure 183).
(Figure 183).
Figure 183: Installing a XENPAK module
2
Slide the XENPAK module as far into the slot as possible, until you hear it click, indicating that it is
firmly attached.
firmly attached.
3
Secure the XENPAK module to the option card by turning the captive screws clockwise until they
are hand-tight.
are hand-tight.
4
Store the antistatic container, dust covers, and card-edge connector protective pad in a clean location
in case you need to remove the XENPAK module.
in case you need to remove the XENPAK module.
5
Remove the dust covers from the module connectors before you connect cables.
6
If only one XENPAK module is installed, attach a supplied cover plate over the other module slot.
ES4K043
XENPAK Module
Cover Plate