Extreme 3802 Installation Guide

Extreme Networks Consolidated "i" and "e" Series Hardware Installation Guide

277

To connect to the F96Ti module, use a 180-degree male RJ-21 connector with a shielded PVC trunk cable 
and secure to a maximum of 4 in-lbs of torque. You can access the ports in one of the following ways:

Through a patch panel by terminating the cable and shield with an RJ-21 connector.

Directly by using a cable that is terminated with 12 RJ-45 connectors.

The RJ-21 connector is shown in Figure 159. For cable specifications, see Table 126 on page 361. 
Appropriate cables are available from your local supplier. 

Figure 159: RJ-21 connector

The default configuration of the F96Ti module is as follows. All ports:

Are added to the default VLAN as untagged.

Inherit the properties of the default VLAN (protocol type, VLANid, and so forth).

Operate in auto-negotiation mode.

The F96Ti module has a module status LED.

For information about the module status LED and its activity on the F96Ti module, see “I/O Module 
LEDs” on page 293.

The F96Ti module requires ExtremeWare version 6.1.8 or later and BootROM 6.5 or later. 

Extreme Networks recommends using iPower power supplies (part numbers 50020, 50021, 50022) with 
F96Ti modules in a BlackDiamond 6800 chassis. A BlackDiamond 6800 chassis with the original power 
supplies (part number 50012) will power fewer F96Ti modules than a chassis with iPower power 
supplies.

Table 60 lists the number of F96Ti modules that you can install in a BlackDiamond chassis depending 
on which power supplies are installed.

XM_046

Screws secure

connector to port