Extreme 3802 Hardware Manual
Configuring I/O Modules
Extreme Networks Consolidated Hardware Guide
249
Software Requirements
The F96Ti module requires that you load ExtremeWare version 6.1.8 or later and BootROM 6.5 or later
on the switch.
on the switch.
F32Fi Module
Figure 126 shows the F32Fi module.
Figure 126: F32Fi module
All F32Fi ports have 32 100BASE-FX ports and use standard MT-RJ connectors.
The default configuration of the F32Fi modules is as follows. All ports:
•
Are added to the default VLAN as untagged.
•
Inherit the properties of the default VLAN (protocol type, VLANid, and so forth).
•
Operate in 100 Mbps, full-duplex mode. Half-duplex mode is not supported.
LEDs
The F32Fi module has the following LEDs:
•
Module status
•
Port status
For information about the LEDs and their activity on the F32Fi module, see “I/O Module LEDs” on
page 271.
page 271.
Software Requirements
The F32Fi module requires that you load ExtremeWare version 6.1.8 or later and BootROM 6.5 or later
on the switch.
on the switch.
BD_F32Fi
Port status LEDs
Module status LEDs
100 Mbps
ports
ports
3
4
2
1
11
12
10
9
19
20
18
17
27
28
26
25
7
8
6
5
15
16
14
13
23
24
22
21
31
32
30
29
4
1
20
17
8
5
24
21
12
9
28
25
16
13
32
29