Extreme 3804 Installation Guide
B
LACK
D
IAMOND
S
WITCH
H
ARDWARE
I
NSTALLATION
G
UIDE
2-5
I
NSTALLING
THE
B
LACK
D
IAMOND
6800 S
WITCH
b
Slide the power supply into the bay.
Caution: Be careful not to slam the power supply into the backplane. Only
use the locking handle for inserting the power supply unit into the chassis.
use the locking handle for inserting the power supply unit into the chassis.
c
Secure the power supply by rotating the locking handle up until it clicks in place,
and then tighten the screws using a #1 Phillips-head screwdriver.
and then tighten the screws using a #1 Phillips-head screwdriver.
6
To install a second power supply, remove the blank plate from the power supply bay
on the right of the chassis using a #1 Phillips-head screwdriver.
on the right of the chassis using a #1 Phillips-head screwdriver.
7
Install the second power supply, as shown in
, by repeating the procedure
described in Step 5.
Figure 2-3: Power supply bays
8
Prior to installing module cards into the BlackDiamond 6800 chassis, put on the ESD
wrist strap that is provided with the chassis, and connect the metal end to the
ground receptacle located on the top-left corner of the BlackDiamond 6800 switch
front panel.
wrist strap that is provided with the chassis, and connect the metal end to the
ground receptacle located on the top-left corner of the BlackDiamond 6800 switch
front panel.
Leave the ESD strap permanently connected to the BlackDiamond 6800 chassis, so
that it is always available when you need to handle ESD-sensitive components.
that it is always available when you need to handle ESD-sensitive components.
9
To install the MSM64i follow these steps:
a
Ensure that the MSM64i is right side up (printed circuit board, or PCB, to the
right) and the ejector/injector handles are extended, as shown in
right) and the ejector/injector handles are extended, as shown in
.
BD_pwrx
DC OUT
AC IN
DC OUT
AC IN