Extreme 3802 Installation Guide
376
Extreme Networks Consolidated "i" and "e" Series Hardware Installation Guide
Installing the Summit Option Card and XENPAK Modules
WARNING!
To prevent ESD damage to the Summit 400-48t, always use an ESD-preventive wrist strap when
installing or removing the module. Handle the module by its sides only. Never touch the card-edge
connectors at the insertion end of the module.
installing or removing the module. Handle the module by its sides only. Never touch the card-edge
connectors at the insertion end of the module.
To install XENPAK modules:
1
Hold the module by its sides and insert it into one of the two slots on the Summit option card
(Figure 183).
(Figure 183).
Figure 183: Installing a XENPAK module
2
Slide the XENPAK module as far into the slot as possible, until you hear it click, indicating that it is
firmly attached.
firmly attached.
3
Secure the XENPAK module to the option card by turning the captive screws clockwise until they
are hand-tight.
are hand-tight.
4
Store the antistatic container, dust covers, and card-edge connector protective pad in a clean location
in case you need to remove the XENPAK module.
in case you need to remove the XENPAK module.
5
Remove the dust covers from the module connectors before you connect cables.
6
If only one XENPAK module is installed, attach a supplied cover plate over the other module slot.
NOTE
To ensure that your module is undamaged upon installation, you can correlate factory test data with
your installation site test data by consulting the average power reference values shown on the XENPAK
module test data sheet (Part No. 121074-00) enclosed with your module.
your installation site test data by consulting the average power reference values shown on the XENPAK
module test data sheet (Part No. 121074-00) enclosed with your module.
Removing a XENPAK Module
To remove a XENPAK module:
ES4K043
XENPAK Module
Cover Plate