Extreme 3804 User Guide

Page of 227
S
UMMIT
 S
WITCH
 I
NSTALLATION
 
AND
 U
SER
 G
UIDE
5-15
C
ONFIGURING
 VLAN
S
 
ON
 
THE
 S
UMMIT
enable ignore-stp vlan <name>
Enables a VLAN from using STP port 
information. When enabled, all virtual ports 
associated with the VLAN are in STP 
forwarding mode. The default setting is 
disabled.
config dot1p ethertype <ethertype>
Configures an IEEE 802.1Q Ethertype. Use 
this command only if you have another switch 
that supports 802.1Q, but uses a different 
Ethertype value than 8100.
config protocol <protocol_name> [add | delete] 
<protocol_type> <hex_value> 
{<protocol_type> <hex_value>} ...
Configures a protocol filter. Supported 
<
protocol_typ
e> values include:
etype
llc
snap
The variable <
hex_value
> is a hexadecimal 
number between 0 and FFFF that represents 
either the Ethernet protocol type (for 
EtherType), the DSAP/SSAP combination (for 
LLC), or the SNAP-encoded Ethernet protocol 
type (for SNAP).
config vlan <name> ipaddress <ipaddress> 
{<mask>}
Assigns an IP address and an optional mask to 
the VLAN.
config vlan <name> [add | delete] port 
<portlist> {tagged | untagged}
Adds one or more ports to a VLAN. You can 
specify tagged port(s), untagged port(s). By 
default, ports are untagged.
config vlan <name> delete port <portlist> 
{tagged | untagged}
Deletes one or more ports from a VLAN.
config vlan <name> protocol 
[<protocol_name> | any]
Configures a protocol-based VLAN. If the 
keyword 
any
 is specified, then it becomes the 
default VLAN. All packets that cannot be 
classified into other protocol-based VLANs are 
assigned to the default VLAN of that port.
config vlan <name> qosprofile <qosname>
Configures a VLAN to use a particular QoS 
profile. Dynamic FDB entries associated with 
the VLAN are flushed once the change is 
committed.
config vlan <name> tag <vlanid>
Assigns a numerical VLANid. The valid range 
is from 1 to 4095.
Table 5-2: VLAN Configuration Commands (continued)
Command
Description
Summit.bk : 5VLAN.FM  Page 15  Thursday, June 18, 1998  9:27 AM