Intermec 6100 Reference Guide
SECTION 5
Communications and Device Support
5-12 PEN*KEY
R
6100 Computer Programmer’s Reference Guide
Protocol Errors
The following tables show valid Protocol error code for (n). This is a number that
specifies the protocol error.
Table 5Ć1
TTY Protocol Errors
Error
Code
Description
0
No error.
6
User aborted communications by pressing EXIT.
11
An invalid parameter was specified in the control file.
23
End of transmission.
101
Line lost.
102
Parity error.
103
Character gap too long.
104
Data loss.
105
Excessive NAKs.
106
Block count error.
107
Block check error.
108
Block framing error.
109
Control character error.
2xx
Modem error. xx is Hayes response code or programĆdefined code:
03 No carrier.
04 Command not recognized.
06 No dial tone.
07 Dialed number is busy.
08 No answer.
86 Error sending command to modem.
87 Expected numeric response was not numeric.
88 Invalid response format.
89 No significant response from modem.
97 System disabled COM port Ċ low battery, PC Card modem removed.
98 Unrecognized English response.
99 Memory allocation error.
03 No carrier.
04 Command not recognized.
06 No dial tone.
07 Dialed number is busy.
08 No answer.
86 Error sending command to modem.
87 Expected numeric response was not numeric.
88 Invalid response format.
89 No significant response from modem.
97 System disabled COM port Ċ low battery, PC Card modem removed.
98 Unrecognized English response.
99 Memory allocation error.
Table 5Ć2
NPCP Protocol Errors
Error # Meaning
0
0
No error.
1
MININET.EXE is not installed.
6
User aborted communications by pressing EXIT.
11
An invalid parameter was specified in the control file.
5. Communications
and Device Support