Intermec 6200 Reference Guide

R

"

1. Connect power to the single dock.
2. Connect a NULL modem cable between the dock and the serial port on the

desktop or portable PC.  For a 6300 Computer, connect the cable to the

COM1 port on the dock.

3. For a 6300 Computer, you can connect an auxiliary keyboard to the dock.

The auxiliary keyboard is not required.  Also note that the onĆboard

keyboard is not functional when an auxiliary keyboard is attached.

However, the backlight and contrast keys continue to work normally.

4. If the PC Card slots contain cards, remove the cards (see the User's Guide

for your HHC, to locate the PC Card slots).

5. Install backup and main batteries.  The backup battery for the 6300

Computer is installed at the factory.  A switch behind the HHC's memory

card door turns the battery on and off (see Figure 1Ć1 below, for location of

switch and batteries).

Ö

Figure 1Ć1

6. Insert the HHC into the dock.
7. Verify the HHC has booted.  If a box is displayed at the top of the screen,

with NORAND UTILITIES", then skip to step 10.  Otherwise, proceed

with step 8.

8. If the Norand Utilities screen is not displayed, press the reset switch on the

HHC.  The reset switch is located behind the memory card door at the top

of the HHC.  On a 6300 Computer, the access hole for the switch is located

behind the card slots and close to the battery door.  On a 6200 Computer,

the hole is located about 1.5 inches from the top of the HHC (see the User

Manual for your HHC, for further assistance in locating the reset switch).

"

9. As the HHC boots and you hear a clicking sound:

"

On a 6300 Computer, with no external keyboard attached, press the

[NEXT] key, or press the [Alt] key on the external keyboard.

"

For a 6200 Computer, press the [F4] key.