Intermec 6200 Reference Guide

R

Topic

Page

Windows Error Codes/Messages . . . . . . . . . . . . . . . . . . . . . . 

3Ć35

IrDA Printing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 

3Ć36

Installation and Configuration . . . . . . . . . . . . . . . . . . . . . . . 

3Ć36

Error Codes and Messages . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 

3Ć41

The following paragraphs describe the Windows 3.1 installation and

configuration for the 6300 Computer.
General information relating to the installing and configuring of Windows 3.1 is

available from vendors, such as Microsoft Corporation.

The standard installation uses SRAM.  The following descriptions relate only to

this type of installation.
You can install Windows on a 6300 Computer by copying the Windows disk to a

memory card or by copying the files to the RAM drive on the 6300 Computer.

You can then start Windows by running the WIN.COM program.  Table 3Ć1 in

the Windows Components paragraph, page 3Ć4, describes the files provided by

Intermec Technologies Corporation.
To illustrate a complete boot sequence from DOS into Windows, the Windows

configuration also includes DOS startup files such as COMMAND.COM,

AUTOEXEC.BAT, and CONFIG.SYS.
The Windows 3.1 package is shipped with a default configuration appropriate for

the 6300 Computer and should require no further configuration to run.

Configurations for drivers provided are described in Sections 2 and 3.

If you are running Windows from a SanDisk or PC Card hard drive or other ATA

device, take note of the following differences.

1. The CONFIG.SYS file on the card is not processed because these types of

cards are not recognized until the CONFIG.SYS  file is processed.  Thus,

the boot drive is actually the flash drive, drive D:\.  The default

AUTOEXEC.BAT file on drive D:\ tries to execute the AUTOEXEC.BAT on

a card in drive B:\ (slot 0 Ċ farthest from the display).  Note that the drive

letter for the device is drive E:\ or F:\, pending on which slot the card is in.

2. Change all references to drive A:\, in the AUTOEXEC.BAT file, so they

reference drive E:\.

3. Remove the WINFILE.INI file in the sample configuration.  This file makes

reference to the A:\ drive when one does not exist.  A default WINFILE.INI

file is created when Windows starts up.