Intermec 5020 User Guide

Browse to the .cab file and tap the .cab file. The .cab file starts installing 
the dcBrowser client. When the installation is complete, the .cab file is 
automatically deleted.

You can now configure and start the dcBrowser client. For help, see 

.

Before you can run the dcBrowser client, you need to configure your 
Intermec computer for networking and then configure dcBrowser to use 
either TCP/IP or UDP Plus.

You need to perform these tasks:

• Configure the Intermec computer for networking.

• Configure the Intermec computer for TCP/IP or UDP Plus 

communications.

Select Start > Settings. The Control Panel appears.

Tap the Connections tab.

Tap Network Cards.

Select the network adapter you are using for your network 
configuration. For example, use the 802.11b PRISM Wireless LAN 
adapter if your network is configured with an 802.11b wireless access 
point.

If you are using a dynamic host configuration protocol (DHCP) server, 
select Use server-assigned IP address.

If you are not using a DHCP server, select Use specific IP address and 
enter the IP address, subnet mask, and default gateway for your mobile 
computer. Your network administrator should provide you with this 
information.

Tap OK. A message appears; tap OK.

Tap OK in the upper right. Tap it again when the next screen appears.

TCP/IP

You need to determine the dcBrowser gateway port number (which 
defaults to 4055) and the IP address of the computer where the 
dcBrowser gateway is hosted.

UDP Plus

You need to determine the UDP Plus port number (which defaults to 
5555) and the IP address of the controller, which is the Intermec 
Application Server or PC that the dcBrowser gateway is running on.