Intermec ck1 User Guide

Page of 172
Chapter 1 — Learning About the CK1 
CK1 Handheld Computer User’s Manual 
Using the CK1 Battery  
 
The lithium-ion battery that is used in this device may 
present a fire or chemical burn hazard if it is mistreated. Do 
not disassemble it, heat it above 100
°
C (212
°
F), or 
incinerate it. 
The main power source for the CK1 is a lithium-ion battery 
(P/N 073659). When you change the battery, the backup 
battery maintains the CK1 status, memory, and real-time clock 
for at least 15 minutes.  
The CK1 has a button under the battery door that lets it know 
when the battery door is removed. If the CK1 is on when the 
battery door is removed, the CK1 turns off. 
 
If you fail to replace the battery immediately, you may lose 
important data or applications.  
 
Note: Do not press the p key when there is no battery 
installed in the CK1. If you turn on the CK1 without a battery, 
you can lose data. For help finding the p key, see “Using the 
Keypad” on page 10. 
Charging the Battery  
You must fully charge the battery before you can use the CK1. 
You can charge the battery before or after you install it into the 
CK1.  
To charge the battery before installing it in the CK1 
1  Place the battery in the battery charger (P/N 073660). For 
help, see the CK1 Battery Charger Quick Start Guide 
(P/N 073776).  
2  Charge the battery until the charger’s Charging light turns 
green to ensure that it is fully charged. The battery takes 
about 4 hours to charge.