Intermec ck1 User Guide
Chapter 2 — Configuring the CK1
34
CK1 Handheld Computer User’s Manual
6 Press Enter to save your changes (or press S1 and Esc to
discard your changes). The System Setting screen appears.
7 (Optional) Configure other CK1 functions.
8 Exit and log out. For help, see “Exiting and Logging Out” on
page 44.
To change the font size that appears on the screen
• You can change the font size from 6x8 to 6x16, add the
change to your application on the CK1. For help, see the
CK1 SDK Programmer’s Reference Manual.
CK1 SDK Programmer’s Reference Manual.
Configuring Bar Code Symbologies
The following procedure explains how to configure the bar code
symbologies settings on the CK1.
symbologies settings on the CK1.
Note: You may need to change the bar code symbology settings,
test those changes, and then make more changes until you get
the CK1 configured correctly. If you use the Barcode icon at the
top level screen to test your changes, you must log back in before
you can make additional changes. Step 5 shows you how to test
the new settings without logging out by using the Barcode test
program available at the Setup screen.
test those changes, and then make more changes until you get
the CK1 configured correctly. If you use the Barcode icon at the
top level screen to test your changes, you must log back in before
you can make additional changes. Step 5 shows you how to test
the new settings without logging out by using the Barcode test
program available at the Setup screen.
To configure bar code symbologies
1 From the System Setting screen, press X to highlight the
Barcode icon, and press Enter. The Barcode screen appears
Barcode
Min Digit:
Max Digit:
Max Digit:
Setting
UG
Code39
125
Enable
Full ASCII
Check Digit
Check Digit
Send Check Digit
Send Start/Stop
0
48
X
X
X