Intermec ck31g User Guide
Chapter 2 — Configuring the CK31G
42
CK31G Handheld Computer User’s Manual
5
For Association, choose WPA and press Enter.
6
For Authentication, choose None and press Enter.
7
For Pre-Shared Key, enter the pre-shared key or the
passphrase.
passphrase.
The pre-shared key must be a value of 32 hex pairs preceded
by 0x for a total of 66 characters. The value must match the
key value on the access point. The passphrase must be from 8
to 63 characters. After you enter a passphrase, the CK31G
internally converts it to a pre-shared key.
by 0x for a total of 66 characters. The value must match the
key value on the access point. The passphrase must be from 8
to 63 characters. After you enter a passphrase, the CK31G
internally converts it to a pre-shared key.
This value must match the passphrase on the authenticator.
8
Exit Intermec Settings.
Configuring WPA Security With Microsoft Security
Use these procedures to set WPA and WPA-PSK security on
your CK31G with Microsoft security.
your CK31G with Microsoft security.
To enable WPA security on your CK31G with Microsoft security
1
Make sure you have configured the communications and
radio parameters on your CK31G.
radio parameters on your CK31G.
2
Open Intermec Settings.
3
Choose Communications > 802.11 Radio > Security
Settings > Microsoft Security.
Settings > Microsoft Security.
4
For Infrastructure Mode, choose Infrastructure.
5
For Network Authentication, choose WPA.
6
For Data Encryption, choose TKIP.
7
For 802.1x Authentication, choose either TLS or PEAP.
If you choose TLS:
a
Select Properties and tap the Run App button. The Auth.
Settings box appears.
Settings box appears.