Intermec cn30 User Guide
Chapter 3 — Configuring the CN30
128
CN30 Mobile Computer User’s Manual
3
Enter the Bluetooth address assigned to your CN30 Computer (shown
in your Bluetooth applet), then click OK to close this dialog.
in your Bluetooth applet), then click OK to close this dialog.
4
The connection label for the SF51 Scanner appears to the right in the
EasySet application, similar to the following. Scan the label once, then
confirm the Intermec Ready-To-Work™ indicator (green light) on the
end of the SF51 Scanner starts blinking, which means it is trying to con-
nect. When connected, the indicator assumes a steady blue, then SF51
data gets wedged through the keyboard interface.
EasySet application, similar to the following. Scan the label once, then
confirm the Intermec Ready-To-Work™ indicator (green light) on the
end of the SF51 Scanner starts blinking, which means it is trying to con-
nect. When connected, the indicator assumes a steady blue, then SF51
data gets wedged through the keyboard interface.
Viewing SF51 Scanner Information from Your CN30 Computer
Note that in the CN30 Computer, the Intermec Settings applet can display
up to seven separate SF51 connections. The following illustration shows
such connections under the Data Collection option.
up to seven separate SF51 connections. The following illustration shows
such connections under the Data Collection option.
In this applet, tap Data Collection, then tap (+) to expand the SF51 Scan-
ner connections to view MAC addresses, firmware version numbers, and
whether each scanner is connected to the CN30 Computer. When you
clear (uncheck) Enable scanner port, the SF51 Scanner is disconnected
from the CN30 Computer. Check Enable scanner port again to reconnect.
ner connections to view MAC addresses, firmware version numbers, and
whether each scanner is connected to the CN30 Computer. When you
clear (uncheck) Enable scanner port, the SF51 Scanner is disconnected
from the CN30 Computer. Check Enable scanner port again to reconnect.