Intermec cn30 User Guide

You can use a Secure Digital (SD) card to increase file storage and install 
software. The CN30 currently supports SanDisk SD cards only. The SD 
card slot is located on the side of the CN30. 

1 Press (I) to turn off the CN30. 
2 Remove the two screws on the SD card slot door and remove the door. 
3 Gently insert the SD card into the CN30 with the printed side facing 
the keypad and screen side of the CN30. 
4 Push the card into the slot until it latches in place and the steel card 
retainer covers the end of the SD card. 
5 Replace the door, making sure to insert the door catch into the slot 
above the steel card retainer.  
6 Replace the two screws. 
7 Press (I) to turn on the CN30. 

1 Press (I) to turn off the CN30. 
2 Remove the two screws on the SD card slot door and remove the door. 
3 Push in on the SD card until you hear it unlatch. The card should eject 
far enough that you can easily remove it from the CN30. If the card does 
not eject easily, you can use the door catch to remove it by turning the 
door upside down and using the catch to pull out the SD card. 
4 Remove the SD card from the CN30.