Intermec ct60 Quick Setup Guide
1
Introduction
—
Chapter
11
CT60 Rugged Tablet PC Quick Start Guide
Troubleshooting
CT60 does not respond to applying power.
Check to ensure that your CT60 Tablet PC is plugged in and
that it is making good contact.
that it is making good contact.
CT60 will not turn
on when the On/Off switch is pressed.
The battery may be low and need recharging.
CT60 won’t power up, screen is blank.
1
Battery may be critically low.
2
Ensure that your computer has been on a charger for at least
five minutes, then remove from the dock and perform the
reset procedure. The display will then be active.
five minutes, then remove from the dock and perform the
reset procedure. The display will then be active.
3
Continue to charge your Tablet PC for 4 hours to ensure that
the battery is fully charged.
the battery is fully charged.
CT60 will not turn
on when placed in a dock.
Ensure that the dock is plugged in and your computer is secure-
ly seated in the dock.
ly seated in the dock.
CT60 shuts down during operation.
You may have a very low battery, try recharging the battery.
CT60 does not turn
off.
1
May not turn off when it is connected to a charging device.
2
May not turn off when it is processing data.
3
If this condition continues for a long period of time it will
run down the battery.
run down the battery.
4
In the event that your Tablet PC locks up, do a warm reset by
pressing the on/off button. A double press replicates <CTRL>
<ALT> <DEL> keystrokes. If you need to do a cold reset,
hold the on/off button down for a longer period of time (4-5
seconds). This causes an emergency forced shut down of the
computer.
pressing the on/off button. A double press replicates <CTRL>
<ALT> <DEL> keystrokes. If you need to do a cold reset,
hold the on/off button down for a longer period of time (4-5
seconds). This causes an emergency forced shut down of the
computer.
5
Contact support personnel at 1-800-755-5505 (US and Can-
ada).
ada).