Intermec 2010 Quick Setup Guide

The battery LEDs allow you to monitor the status of the battery pack inserted
in each battery slot. The following table shows the possible lighting
combinations that you may see and the status each indicates. If you have any
problems, refer to “Battery Troubleshooting” later in this quick reference guide.

 2010Q.006

The charger is waiting for a battery or
there is no power to the charger.

The battery is about to begin charging.

The battery is charging.

The battery is charged and ready.

The discharge button has been pushed and
the slot is waiting for a battery to discharge.

The battery is discharging.

The battery has poor contact with the
charger contacts. (Discharge and
Ready LEDs flash simultaneously)

The battery did not charge in the allotted
time. The battery may be damaged.

The battery has poor contact with the
charger or the battery may be damaged.
(Discharge and Ready LEDs flash alternately.) 

A battery has been inserted that is not
supported by the charger.
(All three LEDs flash in order.)

The battery temperature is out of range.
(Discharge and Ready LEDs flash
alternately with Charge LED.)

A battery has been inserted 
that may be damaged or has a very low 
voltage level. (All three LEDs flash together.)

= off

= on

= flashing