Intermec 2400 Quick Setup Guide

Physical and Environmental
Specifications

Electrical requirements:

xw12V 750mA

Interface:

9-pin D RS-232

Optical interface:

2 IR receivers and 2 IR
transmitters

Optical RS-232 interface:

Converted RS-232 bipolar
signals to optical signals
and vice versa

Interface speeds:

Baud rate up to
38400 baud

Operating environment
Charge Temperature:

32°F to 104°F (0°C to 40°C)

Operating Temperature: -4°F to 122°F (-20°C to 50°C)
Humidity:

0 to 95%, non-condensing

Storage environment
Temperature:

-4°F to 158°F ( -20°C to 70°C)

Humidity:

0 to 95%, non-condensing

Note: The lithium-ion battery pack in the terminal will
not charge below 32°F (0°C).

Design and specifications are subject to change without

notice.

Warning
To prevent fire or electric shock, do
not expose the TD2400 to rain or
moisture.

Avertissement
Pour éviter des risques d’incendie
ou de choc électrique, ne pas exposer
le TD2400 à la pluie ou à l’humidité.

The TRAKKER

Antares TD2400 Communications Dock

is an accessory for the TRAKKER Antares 2420 and 2425
(T2420 and T2425) hand-held terminals. The dock lets
you transfer data and applications to and from another
device by using RS-232 serial communications. The dock
will also charge the batteries inside a T2420 or T2425 that
is inserted into the dock.

This guide describes how to install and use the TD2400
communications dock. Before using the dock, please
read this guide thoroughly and retain it for future
reference.

TRAKKER

Antares

™

TD2400

Communications Dock

Quick
Reference
Guide

P/N 065555-004

2425

2400Q.006

Troubleshooting

If you are unable to establish a good connection or the
green Power Status Light is not on, make sure you
have:

• Set the serial port parameters (for example, baud

rate) to match between the terminal and the device.

• Connected the correct serial cable.

• Ensured that the electrical outlet has power.

• Inserted the terminal firmly in the dock.

• Connected the external power supply to AC

power.

• Cleaned the optical interface windows and ports on

both the terminal and the dock.

• Cleaned the three pins on the dock where you insert

the terminal.

RS-232 Connector Pinout Description

RXD (Receive data)
TXD (Transmit data)
DTR (Data terminal ready)
GND (Signal ground)
RTS (Request to send)
CTS (Clear to send)

2
3
4
5
7
8

2400Q.005

6001 36th Avenue West
P.O. Box 4280
Everett, WA 98203-9280