Intermec 2430 User Guide
Chapter 4—Running Diagnostics
nugget
39 AGaramond
84
Trakker Antares 2400 Family System Manual
Definition: Before you start the test, make sure the radio (Network Activate
command) is enabled. If the radio is disabled, the test results on the Radio
Test screen are not valid. For help, see “Network Activate” on page 210.
Test screen are not valid. For help, see “Network Activate” on page 210.
Press ; to start the radio test. The results of the test appear on the
screen once the test is complete. If SUCCESS or PASSED appear, the
radio is working correctly. If FAILED appears, note the error number. You
may have a problem with the radio inside the RF terminal. For help,
contact your local Intermec service representative.
screen once the test is complete. If SUCCESS or PASSED appear, the
radio is working correctly. If FAILED appears, note the error number. You
may have a problem with the radio inside the RF terminal. For help,
contact your local Intermec service representative.
If the Radio Test fails, stop using the terminal. Contact your local
Intermec service representative.
Intermec service representative.
Attention: Si le test Radio échoue, veuillez ne plus utiliser le terminal.
Contactez le représentant du service clientèle Intermec de votre
région.
Contactez le représentant du service clientèle Intermec de votre
région.
Scanner Test
Purpose: Use the Scanner Test to make sure the integrated laser scanner and scan
button or the tethered laser scanner and scanner trigger are operating
correctly.
correctly.
Where Available: Hardware Diagnostics menu
Sample Screen:
24XXS074.eps
SCANNER
TEST
Press
ENTER
to
turn
the
laser
on
for
3
seconds.
Or,
scan
a
label
to
test
the
laser.
[Enter]
Execute
test
[Esc]
Exit
Definition: To start the test, press ;. If the laser scanner turns on, the scanner is
working correctly. If the laser scanner does not turn on, you may have a
problem with the scanner. If you are using a tethered scanner, make sure
you are using one that is supported on the terminal.
problem with the scanner. If you are using a tethered scanner, make sure
you are using one that is supported on the terminal.
Note: If you are using a 241X with an integrated linear imager, it takes
about 2 seconds for the laser to turn on after you press \. If you are using a
241X with an integrated PDF417 scanner, the laser briefly flashes and
then turns on about 2 seconds after you press \.
about 2 seconds for the laser to turn on after you press \. If you are using a
241X with an integrated PDF417 scanner, the laser briefly flashes and
then turns on about 2 seconds after you press \.