Intermec 2430 User Guide
Chapter 6—Configuration Command Reference
Trakker Antares 2400 Family System Manual
151
Enable UCC/EAN Code 128
Enable ISBT Code 128
*$+CH2*
*$+CH8*
*$+CH2* *$+CH8*
Or: To configure Standard Code 128:
1
Scan this bar code:
Enter Accumulate Mode / Enable Standard Code 128
*+/$+CH1*
*+/$+CH1*
2
Scan one of these bar codes to disable or enable concatenation:
Disable Concatenation
Enable Concatenation
*0*
*1*
*0*
*1*
3
Scan this bar code:
Exit Accumulate Mode
*-/*
*-/*
UCC/EAN Code 128
Description: Enables and configures decoding of the UCC/EAN Code 128 symbology.
When you enable the UCC/EAN Code 128 symbology, it is automatically
configured for concatenation.
configured for concatenation.
If you configure UCC/EAN Code 128, the terminal will decode a bar
code label as Standard Code 128 unless one of the first two characters are a
start character and a Function Code 1. In this case, the bar code label is
processed as described next:
code label as Standard Code 128 unless one of the first two characters are a
start character and a Function Code 1. In this case, the bar code label is
processed as described next:
1
The Function Code 1 character is not transmitted.
2
The three symbology ID characters, ]C1, are transmitted.
3
The remaining Code 128 characters are decoded as Standard Code 128.
Syntax: CH2data
Acceptable values for data must be two digits, corresponding to:
Digit 1:
0
Symbology identifier (ID) disabled.
1
Symbology identifier enabled. Output of ]C1.
Digit 2:
0
Concatenation disabled.
1
Restricted concatenation enabled.