Intermec 2430 User Guide

 

Terminals:  2415, 2425, 2435, 2455, 2461, 2475, 2480/1 with the Ethernet option, 

and 2485/6 using the UDP Plus network. 

 

Description:  Defines the IP address assigned to the Intermec Gateway or DCS 30X in 

your network. An IP address is a unique network level address you assign 
to each device in a TCP/IP network. The controller IP address you set on 
the terminal must match the address that is set on the Intermec Gateway 
or DCS 30X. 

If you plan to enable DHCP (Dynamic Host Configuration Protocol), you 
can set the controller IP address to any valid IP address. The terminal will 
locate and reset the IP address after you enable DHCP.  

If you use the default controller IP address of 0.0.0.0, controller DHCP is 
used to obtain a non-zero controller IP address, even if DHCP 
(Controller) is not enabled. For help, see “DHCP (Controller)” on page 
173. 

 

Syntax: NCn.n.n.n 

where each n address segment is a number from 0 to 255. The controller 
IP address field consists of four separate numbers, each separated by a 
period. 

 

Note: The RF or Ethernet network cannot be activated if the first address 
segment in the IP address is set to 0, 127, or a number greater than 223. 

 

Default: 0.0.0.0 

 

Menu System:  Main Menu > Configuration Menu > Communications Menu > Primary 

Network 

 

Bar Codes:  To set the default controller IP address, scan this bar code: 

Default Controller IP Address 

*$+NC0.0.0.0* 

*$+NC0.0.0.0* 

 

Or:  To set the controller IP address: 

Scan this bar code: 

  Enter Accumulate Mode / Set Controller IP Address 

 

*+/$+NC* 

 *+/$+NC* 

Scan a numeric value from 0 to 255 to set an n field of the controller IP 
address from these bar codes. 

 

*0* 

*1* 

 *0* 

*1*