Intermec 2430 User Guide
Chapter 6—Configuration Command Reference
260
Trakker Antares 2400 Family System Manual
Note: Even if you set this configuration command, the radio on the RF
terminal will reset the parameter as needed to maximize the broadcasting
range and throughput.
terminal will reset the parameter as needed to maximize the broadcasting
range and throughput.
Syntax: RTdata
Acceptable values for data are:
0
BFSK (Binary Frequency Shift Key)
1
QFSK (Quad Frequency Shift Key)
3 Auto
Default: BFSK
Menu System: Main Menu > Configuration Menu > Communications Menu > Radio
Bar Codes: Scan one of these bar codes:
Set Transmit Mode to BFSK
Set Transmit Mode to QFSK
*$+RT0*
*$+RT1*
*$+RT0* *$+RT1*
Set Transmit Mode to Auto
Set Transmit Mode to Auto
*$+RT3*
*$+RT3*
Transmit Rate
Terminals: 2415, 2425, 2435, 2455, 2475, and 2485/6 with 802.11b radios.
Description: Sets the bit rate for data transmissions. A slower transmit rate provides a
better range. You should configure the terminals that are on the perimeter
of the access point coverage area to the slower transmit rate. A faster
transmit rate provides better throughput. You should configure most of
the terminals to the faster transmit range.
of the access point coverage area to the slower transmit rate. A faster
transmit rate provides better throughput. You should configure most of
the terminals to the faster transmit range.
Syntax: LEdata
Acceptable values for data are:
0 Maximum
available
1
1 Mbps (Low)
2
2 Mbps (Standard)
5
5.5 Mbps (Medium)
11 11 Mbps (High)
Default: Maximum
available
Menu System: Main Menu > Configuration Menu > Communications Menu > Radio