Intermec 2430 User Guide

nugget

39 AGaramond

You can run diagnostics on the Trakker Antares

®

 terminals to help analyze 

hardware and firmware problems, fix application problems, and view 
system information. You use the TRAKKER Antares 2400 Menu System 
to run diagnostics. This chapter lists the diagnostics in alphabetical order. 
Use the following tables to find the software, hardware, and system 
diagnostics you want to run. 

 

Note: Diagnostics are not available on 246X terminals, because 246X 
terminals do not use the TRAKKER Antares 2400 Menu System. 

Battery/PIC 
Status 

Shows the power level of the backup battery. 
Indicates the backup battery’s current volts, 
temperature, and charging status. 

Reports main board and the I/O board 
temperature, and the status of the EEPROM 
checksum and the master bus. 

73 

Beeper Test 

Sounds a series of beeps to test the beeper by using 
a range of beep volumes and beep frequencies. 

76 

Display Test 

Tests and turns on the pixels on the screen to make 
sure all areas of the screen are working correctly. 

77 

Hardware 
Configuration 

Lists the terminal’s hardware components that were 
installed at the Intermec factory, including the RF 
country code. 

80 

Keypad Test 

Shows the hexadecimal, decimal, and scan code 
value for any key or key combination on the 
keyboard. 

82 

Radio Test 

(RF terminals only) Tests the radio to make sure it 
is working. 

83 

Scanner Test 

Tests the laser scanner to make sure it is working. 

84