Intermec 9710 Reference Guide
AT&T 615 and 65XX Series
C d 39
2
Configuring the Reader
Scan the appropriate label in this table to configure the reader for your workstation.
After the label is scanned, the reader emits one low beep followed by four low beeps.
The four low beeps indicate the reader has successfully stored the configuration and is
ready to read labels. If the reader emits a different beep sequence, refer to the Wedge
Reader User’s Manual, Section 2, for beep identification.
After the label is scanned, the reader emits one low beep followed by four low beeps.
The four low beeps indicate the reader has successfully stored the configuration and is
ready to read labels. If the reader emits a different beep sequence, refer to the Wedge
Reader User’s Manual, Section 2, for beep identification.
To Set Workstation Configuration to
Scan This Bar Code
AT&T 615
*$+TA320*
*$+TA320*
AT&T 6518, 6578
*$+TA104*
*$+TA104*
AT&T 6528
*$+TA105*
*$+TA105*
AT&T 6529
*$+TA106*
*$+TA106*
AT&T 6538
*$+TA107*
*$+TA107*
AT&T 6539
*$+TA108*
*$+TA108*
AT&T 6579
*$+TA110*
*$+TA110*