Intermec 9710 Reference Guide
C d 39
IBM 3151 and 34XX Series
35
IBM 3151 and 34XX Series
This section covers these workstations:
• IBM 3151
• IBM 3481
• IBM 3471
• IBM 3482
• IBM 3472
• IBM 3486
• IBM 3476
• IBM 3487
• IBM 3477
• IBM 3488
The individual Wedge Interface Guide for this section is part number 054239.
Cables
Use the two cables supplied with this WIF kit to connect the reader to your workstation
and keyboard, as shown in your Wedge Reader User’s Manual. To order a replacement
cable, use these part numbers:
and keyboard, as shown in your Wedge Reader User’s Manual. To order a replacement
cable, use these part numbers:
• Wedge interface kit (P/N 054238)
• Keyboard cable (P/N 054237)
• Terminal cable (P/N 054236)
• Keyboard cable (P/N 054237)
• Terminal cable (P/N 054236)
Power Supply
The reader does not require an external power supply to operate with these
workstations. Set the PCB jumper to connect pins 1 and 2 on the rear panel.
workstations. Set the PCB jumper to connect pins 1 and 2 on the rear panel.
Configuring the Reader
Scan the appropriate label to configure the reader for your workstation. The reader
should emit one low beep followed by four low beeps, indicating that the reader has
successfully stored the configuration and is ready to read labels. If the reader emits a
different beep sequence, refer to the Wedge Reader User’s Manual, Section 2, for beep
identification.
should emit one low beep followed by four low beeps, indicating that the reader has
successfully stored the configuration and is ready to read labels. If the reader emits a
different beep sequence, refer to the Wedge Reader User’s Manual, Section 2, for beep
identification.
To Set Workstation Configuration to
Scan This Bar Code
IBM 3151 model 310
US Keyboard
US Keyboard
*$+TA115*
*$+TA115*
IBM 3151 model 510
US Keyboard
US Keyboard
*$+TA473*
*$+TA473*